So I got a 90 cu ft industrial tank of nitrogen and an oven bag along with a TurboTorch Professional nitrogen regulator (it says for testing and purging brazed joints, no idea). I still haven't got a tube yet and i think i might need to get get some thread tape & lube to connect regulator securely. Plz i need your best advice and I'm willing to buy books or something. do i need a special tube?
-
⚠️ UK Access Block Notice: Beginning July 1, 2025, this site will no longer be accessible from the United Kingdom. This is a voluntary decision made by the site's administrators. We were not forced or ordered to implement this block. If you're located in the UK, we recommend using a VPN to maintain access.
Boochky
Fat, bipolar, and hairy. (Sorry boys, I’m taken.)
- Feb 23, 2019
- 333
I couldn't figure out the tube either. The one I wanted from max dog brewing came with the tubing but it said you had to be 50 to buy from them.
i was thinking about getting a tube off a purge tote kit listed on the welding site but i dont know if the diameter is big enough to support breathing. i haven't opened the regulator from the case for that very reason as i might need to return.
Similar threads
Suicide Discussion
JonCody
Suicide Discussion
cato75
